EAV

A) The Energetic State (the Energetic Report)

The purpose of E.A.V. is to establish an Energetic Evaluation, a Functional Testing of organs and tissues through the measure of Acupuncture and ElectroAcupuncture points in order to determine energetically unbalanced points.

The conductance (capacity to let the stimulation current through) of an organ or a tissue is measured in order to discover energetically unbalanced points knowing that the energetic equilibrium of the human organism is altered, among other things, by the negative ambiance influence exercised by some medications, poisons, insecticides, viruses, bacteria, harmful electromagnetic fields and inflammations as well as certain aliments. The body is the emitting and receiving focus of electromagnetic messages. Cells, as well as the entire organism, constitute what is called in electronics an oscillatory circuit that is capable, if it is submitted to electromagnetic waves, to reach resonance with one of these waves, that is the one that corresponds to the frequency of the circuit. In fact, a very small stimulation current (of about 1 Volt and 10 MicroAmpere) is sent through the acupuncture point. The result of the measurement can be observed on a meter gauge. The ideal measurement is 50. Depending on the results observed on the meter gauge (graduated from 1 to 100).

1° QUANTITATIVES (from 0 to 100)

1. Lower than 50 - indicates a hypo-functioning organ or function (increase of the resistance of the organ to let the current through).
2. Around 50 (tolerance from 50 to 65) indicates a balanced organ or function (equilibrium between the stimulation current and the reaction of the organ).
3. Higher than 50 indicate an hyper-functioning organ or function (low resistance of the organ to let the current through).

2° QUALITATIVES (with needle drops)

When we measure points, the needle does not stay stable at its apogee and starts to fall (more or less rapidly) towards zero. It generally signifies that there exists an Energetical Disequilibrium at the level of the meridian being measured. These measurements are to be preferred.

The ensemble of these measures (QUANTITATIVES + QUALITATIVES) permits one to establish the ENERGETIC LEVEL of the person.

B) Manifestation of the Accord of Frequencies

Thereafter one may restore energetic imbalances with the addition of products and by the MANIFESTATION OF THE ACCORD OF FREQUENCIES between the needs of the person and the product introduced in the circuit being measured. That is what the Dr. Voll called ‘the Medicament Test.’ He observed that by depositing a product in the circuit and if that was the appropriate product, it will correct the fall of the needle and will help the body to re-equilibrate itself.

The most important point of that discovery is that a vibrating information source, representing the product, is transported or conveyed by the electric current following the acupuncture meridian to the organ in question.

In practice, this means:

When testing a product on a disturbed point (with fall of the needle), the following observations can be found after placing the product to be tested in the circuit:

1. If it does not redress the needle drop, the product is not in vibratory harmony with the needs of the individual.
2. If it redresses partially the needle drop, the product is helpful but not the most suited.
3. If it redresses totally the needle drop, the product is in vibratory harmony with the individual's needs.
4. It is interesting to note that, in certain cases, it is possible to replace the product determined to redress the needle drop by a Manual Therapy such as Massage, Kinesiology, Reflexology, Microkinesitherapy, Osteopathy, Traditional Acupuncture, or other techniques, such as the Chromatherapy, and to control it thereafter.

C) Control of Product Taking

Furthermore the EAV technique permits control very quickly if a given product, at the moment of the test, is IN HARMONY with the needs of the person being tested. This allows continued control if a person keeps taking the vitamin, dietary product, mineral element, etc.

In practice, it means that when testing a product on a stable point (without fall of the needle), the following observations can be found after placing the product to be tested in the circuit:

1. The needle falls, that is the product can provoke a new energetic imbalance.
2. The needle holds its original position, that is the product has no apparent effect.
3. The needle measurement is higher than the original reading, that is the product is energetically beneficial.